Hydration Pack Maintainance Tips

hgghghgghghggh

For hikers and mountain bikers, a hydration pack comes in handy. A hydration pack is a form of hydration system that is built as a backpack or a waist pack that holds a reservoir commonly referred to as a bladder. The bladder is mainly made of rubber or plastic that is flexible. The bladder has a mouth that is capped and a tube to enable the wearer to quench thirst while hiking or biking thus being hydrated through the activity. The tube has bite valve that opens when the user is drinking the fluid. Therefore, a hydration pack is important, and that calls for good maintenance. For the best hydration pack read this blog further.

Tips

Cleaning the bladder

jhjhjhjhjhjkkkkAlways wash the bladder after use. Use warm water and soap to clean the reservoir. Ensure the bladder is rinsed thoroughly to ensure there are no traces of soap left out. You can wipe water on the bladder to speed up the dying process. If the bladder is left unwashed, it can be a breeding ground for bacteria and mold. You can also use toothbrush to clean the bladder

Get rid of the mold

What if the reservoir contains mold and bacteria? If you don’t clean the bladder after every use mold and bacteria can thrive. You can use warm water mixed with two tablespoons of baking soda. Let the solution sit in the bladder for 30 minutes, wash with soapy warm water, rinse and dry out. You can rinse the bladder with lemon water. The lemon water leaves an aftertaste that is pleasing.

Cleaning the pack

The pack can be wiped with a damp cloth or washed with soapy water depending on how dirty it is. However, it is advisable to always wipe it. Hang it to dry. You should never wash the pack in a washing machine; this is because it can twist the pack or even cause the straps to tear.

Cleaning the tube and the bite valve

You can acquire a long brush that is thin to enable you to clean the tube. You can also use a homemade cleaning material, for example, a wire that is long enough together with a piece of cloth. You should bend the wire at the end and attach the piece of fabric. Wash the tube by pushing the wire inside the tube. Repeat severally until sparkling clean. You can use vinegar or a bleach if need be to clean the tube. Rinse the tube and squeeze the bite valve; this will ensure that all the residual is cleaned out.

Dry out all the parts and store in a freezer

hghgghhhghghgAll the systems of the hydration pack should be kept dry. If water is left out, it can allow bacteria to thrive and molds as well. Dying all the parts is paramount. After the tube and the bladder are dry, you can store them in the freezer. Thanks to technology, the bladders are of the size to be stored in the freezer. No bacteria can survive inside a freezer.